The California Look, Classic Volkswagen Beetle, Bus, Ghia, Street and Racing

Navigation
News

May 23, 2012, 11:53:24 pm
Pages: [1]   Go Down
Print
Author Topic: Washers for 0.190" Ercos  (Read 388 times)
JOEvig59
Newbie
*
Offline Offline

Posts: 1


« on: January 07, 2011, 04:12:00 pm »

I know there are quite a few posts on here regarding the mounting hardware for Ercos but after reading through them all, none of them really answered my question.  My question is can you use the aluminum washers intended for the 0.125" thick Ercos (flat surface) on the 0.190 Ercos (countersunk)?  I know I don't need them but I think they're a good idea and like the way they look.  My worry is that the hole for the stud may "oval out" over time do to the void space and low contact area between the wheel and stud.  Is anybody else running these washers on a set of 0.190" thick Ercos and have you had any problems with this?  Or is there a washer similar that also compensates for the countersink?  Thanks for any help.
Logged
Pages: [1]   Go Up
Print
 
Jump to: