spare parts mouse turbo build

[Aussie Rob]

Just playing around with my spare parts. Using an A.J. Sims T600 kit with a 350 holley and a t3 turbo 1 3/8 exhaust.
 Engine is a 1745cc  with a 76x85.5
 Cb 1:1.1 Rhino Rockers
 Cb 2241 cam 240*@50thou and .424 lift @ valves
 Los Panchito 40x35.5 heads duel valve springs
 I have an old single port 1300 F case which i want to use for this application. I have it full flowed and converted to a dog house cooler.
 I also have a set of old vw rods which have been re-manufactured by Pauter which i bought from CB back in 1998.
 I was wondering how this combo would perform running any where between 8-16lbs boost with the cam and head combo?
Would a set of stock non ported heads work better,more lift on the cam?
Any advice would be appreciated...




 

[martin]

My old AJ turbo build was a 1776 Berg with stock ported heads semi-hemi'd at 7:1. With the Berg 110 cam it made lots of power (150?) with the boost cranked up to 15 psi and ran ok on Reg gas, but was hard to tune.  It's a street car, and fun to drive, not sure what you have.

[Joel Mohr]

Our 1600 turbo build was all stock with a Web 119 and we got 120 hp and 140 torque at 8 psi.....we used a Kadron for our carb...

[Aussie Rob]

This  engine is just a fun weekend toy. Drivability can take a back seat. Will be using 98ron pump with higher boost levels.
I gather stock size valves and a good port job would give excellent port velocity for the small motor instead of the 40x35.5 valve heads.