Flanged crank and thrust setup?

[-Alex-]

I have decided to buy flanged crank, what is the best thrust setup with them?


I have few times seen Jeff D:s cases, where he has put with  bronze shims with screws to the center main.

I could have these made by my own design, but where i could buy these shims?

[Ohio Tom (DdK)]

If you wanna go that rout, just have JC enterprizes or someone reputable do the work.
It's trickey to get right and best left to the experts IMO.

I just went with the standard (special cut) T4 bearings.
They usually end up around .007-.009" thrust. That's OK for most applicatioins.