48 idf's jetting suggestions

[chadt]

just looking for some suggestions for jetting.

2276, cb oval port cnc 42 x 37, fk 44, 1 5/8 exhaust, 48 idfs.

i ran 40 vents, 60 idles, 160 mains, 190 airs on my 2176 w/ smaller heads.  maybe bigger airs? sea level tuning.

[fastjesse]

What emulsion tube are you running?

[Mark Harney]

I ran 57/150/200 with F11's on 40 vents with my 12:1 2332.  I've retuned with 42 vents and I am currently at 55/160/200.  If you're going for power, 57 or 60 idles, 160 mains, 200 airs sounds about right on F11.  If you're using F2, about the same idles, and 150/180 ought to get you close.  Set those floats to 11mm!  It'll never tune right until you do.

[chadt]

thanks guys.  i have f-11's and floats are set at 11mm but that will all be double checked before installed again.  so 60 idles, 160 mains, and 190 airs (until i get 200's) should be in the ball park.